Retrospect client windows 75/6/2023 ![]() Retrospect Ranks Highest in Diogenes Labs- Storage magazine Quality Awards. ![]() ![]() Retrospect provides easy-to-manage, automated, reliable data protection for: Servers, Desktops and Notebooks Mac, Windows, Linux, Solaris, NetWare Mixed heterogeneous environments Small and Medium Businesses (SMB) Companies from users Small Offices and Home Offices (SOHO) 1-5 Users The Distributed Enterprise remote/branch offices, workgroups Government and Education Similar size to SMBs Lacking an EOD, the tape will later produce error –206 when you try to append (write data) to it with Retrospect.Presentation on theme: "Retrospect Sales Presentation"- Presentation transcript:Ģ Retrospect protects millions of computers world-wide Tape drives are responsible for writing EOD markers, but a drive may not get the chance if you shut down or restart the backup computer or the power is interrupted. If a tape does not have an EOD marker Retrospect may report error –206 when it next tries to append to the tape. ![]() Some tape drives require an end of data (EOD) marker on a tape to append data. Retrospect can also report error –206 when a crash or power failure interrupts the backup computer or tape drive. Also see FireWire and USB Device Issues and SCSI Issues. Try using your backup device on another computer to see if interference is caused by your monitor or other nearby electronic devices. Try removing one or more devices temporarily to see if there is some other device conflict. If you have a drive immediately next to another electronic device, try moving the devices further apart. Consult the manual that came with your tape drive or contact the drive manufacturer for cleaning recommendations.Īnother device is causing interference. The heads on the tape drive are dirty and need to be cleaned. The media is physically defective and needs to be replaced. Contact your drive vendor for advice before assuming a drive needs repair. If tapes are recognized in one drive but not another of the same type, it is possible that one drive needs repair. If possible, try your tape or tapes in a compatible tape drive. See SCSI Issues for detailed instructions on troubleshooting your SCSI bus. If all tapes are unrecognized, then they were either all created in a different tape drive, there is a problem with your SCSI configuration, or your tape drive may be broken. If only one tape does then either it is damaged, it has been written to by other backup software, or it was created in a different, incompatible tape drive. Tape drives need to be cleaned regularly with special cleaning cartridges (see Cleaning Your Tape Drive).Ĭheck if other tapes also show as content unrecognized. Refer to the Retrospect web site for current information on tapes that each tape drive supports.Ĭlean your tape drive and continue to clean it according to your drive vendor’s recommendations. For example, DDS-4 150 meter tapes cannot be read by DDS-1, -2, or -3 drives. Make sure the tape cartridge you are inserting is compatible with your tape drive.
0 Comments
Leave a Reply. |